







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
See the difference
Before
After
Before
After
Before
AfterSmall Kitchen Remodel Cost in Enterprise, NV: What the Number Actually Looks Like
A small kitchen remodel in Enterprise - new cabinets, countertops, sink, and hardware with no layout change - runs $18,000-$32,000 depending on cabinet line and countertop material, and the broader range across our small-kitchen projects lands between $9,000 and $20,000 for tighter scopes. That range holds only if the existing electrical panel can carry a modern refrigerator, dishwasher, and microwave circuit load. In a lot of 1990s Enterprise tract homes, it can’t - which is where a $1,500-$3,500 panel upgrade shows up that national estimate tools never put on the page. Call (833) 630-4077 and we’ll put a written price in front of you before anything gets demoed.

Why Enterprise Estimates Come In Lower Than the Real Bill
Enterprise is tract housing built from the 1990s through the 2020s - two-story Mediterranean and Southwestern stucco homes with concrete tile roofs on small master-planned lots. The kitchens in that housing stock share a handful of traits that throw off a national cost calculator, and they’re the same traits that make an honest local quote necessary. Under Clause 1 of the Haven Standard, the price is written before anyone starts, so those traits get priced up front instead of discovered on day three.
The first is the panel. A 1990s tract kitchen was wired for the appliances of its era. A modern refrigerator, dishwasher, disposal, and microwave on dedicated circuits can exceed what the original panel and service were sized for. Without capacity, the remodel hits a wall that isn’t carpentry - it’s electrical, and it’s real money.
The second is the soffit. Those kitchens were built with 30-inch upper cabinets under an 8-foot ceiling, leaving a 12-inch soffit band above. If you want 42-inch uppers, which is the current standard, that soffit gets framed out or demoed. That’s a scope addition, and we price it in the written estimate when you ask for the upgrade, with a signed change order before demo starts.
The third is permitting, and it’s where a lot of homeowners get surprised. Clark County does not require a permit for a cosmetic kitchen remodel - cabinets, countertops, like-for-like appliances. It does require one for any electrical circuit addition, plumbing relocation, or structural wall modification. We tell you which category your project lands in before the written price is delivered, so there are no permit surprises mid-project. Projects in unincorporated Enterprise run under county inspection rules, not city rules, and that distinction matters for scheduling.
Cabinet Line Is the Biggest Single Variable
Cabinet line drives cost more than anything else in a small kitchen. We source across fifty-plus vetted brands, and for kitchens at this scale the two that come up most are KraftMaid and Wellborn, and they’re not the same purchase.
- KraftMaid semi-custom uses stock sizing with 30-plus finish options. Installed in a small kitchen, it runs $8,000-$14,000.
- Wellborn full-custom is built to the inch, which matters in a small kitchen where a half-inch of filler is the difference between a usable corner and a dead one. It runs $12,000-$20,000.
We name the brand and the price in the written quote - not a range after the fact. That’s the discipline Haven acquired Rowan for, and it’s why our projects finish within a few percent of the agreed number instead of drifting.

Countertop Material: The Second-Largest Swing
Quartz is the default in Enterprise kitchens because it handles the desert heat and won’t stain the way a porous stone will. Caesarstone runs $55-$85 per square foot installed; Cambria runs $70-$110 installed. In a small kitchen with about 30 square feet of counter surface, that’s a $600-$750 swing per linear foot of upgrade between entry and premium quartz. It belongs in the quote, not the invoice.
Here’s the line-item view. These are the ranges we work from in Enterprise and across the southern Las Vegas Valley:
| Item | Price Range |
|---|---|
| Small kitchen remodel (full scope) | $9,000-$20,000 |
| Kitchen remodel (broader scope) | $14,000-$45,000 |
| Cabinet installation | $4,000-$13,000 |
| Countertop installation | $2,000-$6,500 |
| Backsplash installation | $800-$2,500 |
| Kitchen island installation | $3,000-$10,000 |
| Electrical panel upgrade (if required) | $1,500-$3,500 |
For a closer look at how a full-scope job breaks down versus a tight refresh, see our Kitchen Remodeling service page. For a small kitchen specifically, Kitchen Remodeling in Enterprise covers how we sequence the work in these tract homes.
Three Enterprise Kitchen Scenarios and What They Cost
Scenario 1: Facelift on a 1998 Tract Kitchen
Original oak cabinets get refaced, countertops go to Caesarstone, and the sink and disposal stay where they are. No new circuits, no soffit work. This is the least expensive path, typically $9,000-$14,000, because it stays in the cosmetic category and needs no Clark County permit. Our technicians have up to 19 years of experience with exactly this kind of builder-grade refresh.
Scenario 2: New Uppers, New Panel
KraftMaid semi-custom cabinets go in, the soffit comes down to make room for 42-inch uppers, and the panel gets upgraded to carry the new appliance load. The soffit demo brings a signed change order; the panel work brings a permit. Typically $18,000-$26,000. This is the scenario most Enterprise homeowners actually land in once they learn the 42-inch uppers don’t fit under the original soffit.
Scenario 3: Wellborn Custom in a Tight Galley
Full-custom cabinetry built to the inch in a narrow galley where stock sizing leaves dead corners, Cambria countertops, a small island if the footprint allows. Typically $26,000-$32,000. The kitchen doesn’t get bigger, but every inch earns its keep.
What You Get in Writing Before Work Starts
Rowan Construction Group Enterprise works under The Haven Standard: a flat written price and a written scope before any work begins, no work on a change until the change order is signed, a background-checked and uniformed crew, a documented photo record on every visit included as standard, and a live person answering calls 24/7. The 365-Day Done Right Promise backs the finish: if it isn’t done right, we make it right. And if you have a competitor’s estimate in hand, we’ll review it line by line at no charge as a free second opinion - that’s a standing offer, not a sales tactic.
Kitchens are the trade we started with, and the reason is simple: a kitchen has more moving parts per square foot than anything else in the house, which makes it the easiest place for a quote to drift. The signed change order is how it doesn’t.
FAQs
A small kitchen remodel in Enterprise typically runs $9,000-$20,000, with the most common full-scope projects landing around $18,000-$32,000 once you add a panel upgrade or soffit work for 42-inch upper cabinets. The lower end is a cosmetic refresh with no layout change and no new circuits; the upper end includes semi-custom or full-custom cabinetry and a premium quartz top. Call (833) 630-4077 for a free, written estimate.
Clark County does not require a permit for a cosmetic kitchen remodel - cabinets, countertops, like-for-like appliances - but it does require one for any electrical circuit addition, plumbing relocation, or structural wall modification. We identify which category your project falls into before the written price is delivered, so a permit never shows up as a mid-project addition. Unincorporated Enterprise runs under county inspection rules, and we schedule around them. Call (833) 630-4077 and we’ll tell you which side of the line your kitchen sits on.
Refacing is cheaper than replacing when the cabinet boxes are solid and the layout stays the same - usually $4,000-$8,000 versus $8,000-$14,000 for KraftMaid semi-custom installed. The deciding factor is the box, not the door: if a technician finds water damage at the sink base or particle board that’s swelled from a past leak, refacing puts a new face on a failing structure. We check that before we quote, not after. Call (833) 630-4077 for a free second opinion on any competing quote.
We answer calls 24/7 with a live person, and we schedule estimates as fast as the calendar allows, often within a day or two. The estimate visit includes a documented photo record of what we find - the panel, the soffit, the cabinet boxes - so you leave with evidence, not a promise. Every estimate is free and comes with a flat written price and written scope. Call (833) 630-4077 to get on the schedule.
Get the Number in Writing
If your Enterprise kitchen is due for a refresh, the first step is a written price - flat, with a written scope, before anyone picks up a tool. Call (833) 630-4077 for a free estimate, and bring a competitor’s quote if you have one. We’ll review it line by line and show you where the $1,500-$3,500 panel line either belongs in the price or doesn’t.
Written by the team at Rowan Construction Group Enterprise, serving Enterprise, NV.
What Our Customers Say
"Fence and retaining wall along a sloped boundary. They photographed the footing depth at each post, which mattered when the county inspector came."
- Iona F."Final invoice was within two percent of the contract. Every change was priced and signed before anyone picked up a tool."
- Malcolm T."Driveway replaced properly with a base that will actually last. They explained why the cheaper quote was cheaper."
- Reggie O.












